These 3D or Modular Origami Models are made of many .
Instructions with images – coming soon !!!
© 2010, Arati Dhareshwar. ALL RIGHTS RESERVED. ON REPUBLISHING THIS POST YOU MUST PROVIDE LINK TO THE ORIGINAL POST
3D / Modular Origami
August 18, 2010 3 Comments
Encaustic Paintings
August 18, 2010 4 Comments
Encaustic Paintings are wax paintings. Tools used – Non-Teflon Iron , Heat Gun. Can be done on various surfaces like paper , ceramic tile , canvas , tempered glass.
© 2010, Arati Dhareshwar. ALL RIGHTS RESERVED. ON REPUBLISHING THIS POST YOU MUST PROVIDE LINK TO THE ORIGINAL POST
Iris Folding – X’mas Tree
September 6, 2009 3 Comments
- Take a Christmas Tree pre-cut design stencil.
- Take 4 colour glitter papers. Cut them into small strips of 2 cm wide and 6cm of lenght. Fold the long edge of the strip by 3/4 cm.
- C0lour A – Brown – used for the bark of the tree
- Colour B – Red – Start from the left side corner and bring it to the centre.
- Colour C – Green – Start from the right of the tree to bring it to the centre of the tree
- Colour D – Goldern – Strart at the base of the tree (above the bark) to nring it to the centre of the tree.
- Now start placing the folded strips to the edge of the stencil and make sure you are working on the rear/wrong side of the stencil and sticking the strips with cello tape.
- Continue sticking the strips in sequence (i.e. red, then green and golden) until you reach the centre . As you finish you will notice that the order is moving in a clockwise direction.
- You can stick any colour paper in the centre or leave it empty, as per your wish.
© 2009, Arati Dhareshwar. ALL RIGHTS RESERVED. ON REPUBLISHING THIS POST YOU MUST PROVIDE LINK TO THE ORIGINAL POST
