DIY Gladiolus Paper Flower

3

 

crepe-paper.jpg

Materials Required

Crepe Paper Flower
Floral Tape
Floral Wire
Glue

How to do

To form the buds of the plant, I bunched up a small piece of crepe paper flower . After wrapping floral tape around the base of the pinched paper , I attached it to a 12 inch long piece of 16 gauge floral wire. Several more buds, made in a similar manner, were then attached to the wire in an alternating pattern . The amount of paper in the buds should gradually increase as one continues down the wire.

In order to make the flowers, I needed to cut out several circles of paper. I drew the designs, cutting wavy edges around the perimeter of the circles. The circles ranged from around 1.5-2 inches in diameter. After layering two of the circles, a piece of 26 gauge wire was looped through the middle of the circles. The circles were then pinched around the wire and one of the ends was wrapped around the base of the flower. Floral tape was wrapped around the exposed wire completing the rudimentary flower. Next, I attached the flowers in increasing size in the same alternating pattern as before

3 COMMENTS

LEAVE A REPLY

Please enter your comment!
Please enter your name here

:( more »